Setting the SE Linux state

When installing CTE-U on SE (Security Enhanced) Linux with RHEL 9.1, you must set the SE Linux state. SELINUX can be set to any of the following three states:

• Enforcing: SELinux security policy is enforced.

• Permissive: SELinux prints warnings, but does not enforce the security policy.

• Disabled: No SELinux policy is loaded.

Installing CTE-U and Setting the SE Linux State

1. Check if SE Linux is in enforcing mode with the command sestatus.

   [root@localhost ~] sestatus
   

   Response

   SELinux status: enabled
   SELinuxfs mount: /sys/fs/selinux
   SELinux root directory: /etc/selinux
   Loaded policy name: targeted
   Current mode: enforcing
   Mode from config file: enforcing
   Policy MLS status: enabled
   Policy deny_unknown status: allowed
   Memory protection checking: actual (secure)
   Max kernel policy version: 33
   

2. If it is in enforcing mode, set the state to permissive for installation, type:

   [root@localhost ~] setenforce 0
   

3. Install CTE-U and register the client to CipherTrust Manager.

4. Run the following commands, in succession, to add the SELinux policy for CTE-U.

   grep -i "comm=\"secfs_fuse\"" /var/log/audit/audit.log | audit2allow -M secfs_fuse
   semodule -i secfs_fuse.pp
   
   grep -i "comm=\"vmd\"" /var/log/audit/audit.log | audit2allow -M vmdpolicy
   semodule -i vmdpolicy.pp
   

5. Restart the SecFS_fuse service and check the logs for any AVC denials in /var/log/messages.

   A denial for setattr is expected after adding a policy for vmd. If you see the message "SELinux is preventing" to any of the processes "secfs_fuse, vmd". Then execute the command mentioned in step 4 again.

6. Change the SE Linux status to enforcing once there are no more denials, type:

   setenforce 1
   

   Note

   For more information, see Setting SELinux states and modes.

Setting the SE Linux Policy Type

The SELINUX TYPE will be one of the following three values:

• Targeted: Targeted processes are protected

• Minimum: Modification of targeted policy. Only selected processes are protected.

• MLS: Multi Level Security protection.

The following file controls the state of SELinux on the system.

    /etc/selinux/config

• Edit the /etc/selinux/config file to set the SE LINUX TYPE parameter to SELINUXTYPE=targeted.

Disabling SE Linux

In earlier Fedora kernel builds, setting SELINUX to disabled would also fully disable SELinux during the boot stage. If you need a system with SELinux fully disabled, as opposed to a system with SELinux running with no policy loaded, you need to set selinux=0 in the kernel command line. Use the Grubby CLI tool.

To set the bootloader to boot with SE Linux disabled, type:

    grubby --update-kernel ALL --args selinux=0

To revert back to SELinux enabled, type:

    grubby --update-kernel ALL --remove-args selinux